Nissan Juke Service and Repair Manual : Removal and installation
- CVT shift selector
- Control cable
- Key interlock cable
- Transmission range switch
- TCM
- Air breather hose
- G sensor
- Control valve
- Primary speed sensor
- Secondary speed sensor
- Differential side oil seal
- Oil pump fitting bolt
- Water hose
- Fluid cooler system
Symptom diagnosis
SYSTEM SYMPTOM Symptom Table The diagnostics item numbers show the sequence for inspection. Inspect in order from item 1. ...CVT shift selector
Exploded View 1. Selector lever knob 2. Lock pin 3. Knob cover 4 Position indication panel 5. CVT shift selector assembly 6. CVT shift lock unit 7. Key interlock rod* 8. Indicator lamp ...Other materials:
Combination meter
Reference Value
VALUES ON THE DIAGNOSIS TOOL
NOTE:
Some items are not available according to vehicle specification.
TERMINAL LAYOUT
PHYSICAL VALUES
Fail-Safe
FAIL-SAFE
The combination meter activates the fail-safe control if CAN communication
with each unit is malfuncti ...
P1550 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...