Nissan Juke Service and Repair Manual : Removal and installation
Refilling
1. Remove filler plug (1) and gasket from transaxle case. 2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure. Oil grade and v ...Side oil seal
Removal and Installation REMOVAL 1. Remove front drive shafts. Refer to FAX-53, "Removal and Installation". 2. Remove differential side oil seals (1) from clutch housing and transaxle ca ...Other materials:
EGR valve
Exploded View
1. EGR valve assembly
2. Clamp
3. EGR tube
4. Air inlet tube
5. O-ring
6. Gasket
7. EGR cooler
8. Gasket
9. EGR volume control valve housing
10. Gasket
11. Electric throttle control actuator
12. Gasket
13. EGR volume control valve
14. Clamp
15. Cooling hose
...
Drive belt
Checking Drive Belts
WARNING:
Be sure to perform when the engine is stopped.
1. Inspect belts for cracks, fraying, wear and oil. If necessary,
replace.
2. Evaluate manually if the belt is enough tensioned (tension cannot
be measured by way of frequency meter).
CAUTION:
Auto-tensioner must ...
P0045 TC boost control solenoid valve
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK TURBOCHARGER BOOST CONTROL SOLENOID VALVE POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect turbocharger boost control solenoid valve harness connector.
3. Turn ignition switch ON.
4. Check the voltage between turbochar ...