Nissan Juke Service and Repair Manual : Removal and Installation
REMOVAL
1. Separate the rear propeller shaft. Refer to DLN-121, "Removal and Installation".
2. Remove right side drive shaft. Refer to FAX-24, "RIGHT SIDE : Removal and Installation".
3. Remove catalyst convertor support bracket (RH). EM-35, "4WD : Removal and Installation".
4. Remove heat insulator (1).
5. Remove transfer gusset (1).
6. Remove catalyst convertor upport bracket rear. EM-59, "4WD : Removal and Installation".
7. Remove rear torque rod and rear torque rod bracket. Refer to EM-59, "4WD : Removal and Installation".
8. Remove the mounting bolts of transaxle assembly and transfer assembly.
9. Remove transfer assembly from the vehicle.
: Vehicle front
CAUTION:
Never damage ring gear shaft.
INSTALLATION
Note the following, and install in the reverse order of removal.
• When installing the transfer to the transaxle, install the mounting bolts following the standard below.
CAUTION:
• When installing transfer assembly to transaxle assembly,
replace the side oil seal (transfer joint). Refer to TM-292,
"Removal and Installation".
• Never damage side oil seal (the joint part of transfer).
• When installing heat insulator (1), install the mounting bolts and nut following procedure.
• Check oil level and check for oil leakage after installation. Refer to DLN-90, "Inspection".
Exploded View
1. Transfer gusset 2. Transfer assembly 3. Heat insulator : Vehicle front : N·m (kg-m, ft-lb) ...Other materials:
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
License plate lamp
Exploded View
1. License plate lamp housing assembly
2. Blub
3. License plate lamp blub socket
: Pawl
Removal and Installation
CAUTION:
Disconnect battery negative terminal or remove the fuse.
REMOVAL
1. While pressing the license plate lamp to direction right side, pull
it to directio ...
MR16DDT : Inspection and Adjustment
INSPECTION
Magnetic Switch Check
• Before starting to check, disconnect the battery cable from the negative
terminal.
• Disconnect “M” terminal of starter motor.
1. Continuity test [between “S” terminal (A) and switch body]
B : “B” terminal
C : “M” terminal
• Replace magnetic switch if co ...