Nissan Juke Service and Repair Manual : Removal and installation
Refilling
1. Remove filler plug (1) and gasket. Then fill oil up to mounting hole for the filler plug. : Vehicle front Oil and viscosity : Refer to MA-13, "Fluids and Lubricants". Oil capacity : ...4WD control module
Removal and Installation REMOVAL 1. Turn the ignition switch OFF. 2. Remove front (left side) seat. Refer to SE-27, "Removal and Installation". 3. Remove floor carpet. Refer to INT-23, & ...Other materials:
How to use brightness control and display ON/OFF button
To change the display brightness, push the
button. Pushing the button again will
change the display to the day or the night display.
If no operation is performed within 5 seconds, the display will return to the
previous display.
Push and hold the button for more
than two seconds to turn t ...
P0403 EGR volume control valve
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK EGR VOLUME CONTROL VALVE CONTROL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect EGR volume control valve harness connector and ECM harness
connector.
3. Check the continuity between EGR volume control valve terminal harness
co ...
Removal and Disassembly
• When instructed to use SST, use specified tools. Always be careful to work
safely, avoid forceful or uninstructed
operations.
• Exercise maximum care to avoid damage to mating or sliding surfaces.
• Dowel pins are used for several parts alignment. When replacing and
reassembling parts with ...