Nissan Juke Service and Repair Manual : Removal and Installation

REMOVAL

1. Disconnect accelerator pedal position sensor harness connector.

2. Loosen mounting bolts, and remove accelerator pedal assembly.

CAUTION:
• Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly.

• Avoid impact from dropping etc. during handling.

• Be careful to keep accelerator pedal assembly away from water

.

INSTALLATION

Note the following, and install in the reverse order of removal.

• Insert the locating pin while inserting the locating hook in to the break pedal bracket. Tighten mounting bolts to accelerator pedal assembly.

CAUTION:
Never squeeze the locating hook into the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.

    Exploded View
    1. Accelerator pedal assembly 2. Brake pedal bracket A. Locating hook B. Locating pin : N·m (kg-m, in-lb) ...

    Inspection
    INSPECTION AFTER INSTALLATION • Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released. • Check accelerator pedal securely returns to the ...

    Other materials:

    Measurement of weights
    Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the Gross Axle Weight Ratings ( ...

    Refrigerant pressure sensor
    Exploded View Refer to HA-39, "Exploded View". (HR16DE) Refer to HA-94, "Exploded View". (MR16DDT) Removal and Installation REMOVAL Remove refrigerant pressure sensor. Refer to HA-42, "REFRIGERANT PRESSURE SENSOR : Removal and Installation". (HR16DE) Refer to ...

    P1805 brake switch
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Fully depress the brake pedal for at least 5 seconds. 3. Erase DTC. 4. Check 1st trip DTC. Is 1st trip DTC detected? YES >> Go to EC-734, "Diagnosis Pr ...