Nissan Juke Service and Repair Manual : Removal and installation
Fuel filter
Exploded View Removal and Installation REMOVAL (RHD) 1. Remove quick connectors in the following procedures. • Pinch quick connector square-parts with your fingers, and pull out the quick c ...Fuel level sensor unit
Exploded View 1. Lock ring 2. Fuel level sensor unit 3. Seal packing A. To fuel tank : Always replace after every disassembly Removal and Installation WARNING: Read “General Precautions” ...Other materials:
B26F0 steering lock relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B26F0 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
BCS-83, "DTC Logic".
• If DTC B26F0 is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
BCS-84, "D ...
Stall test
Work Procedure
INSPECTION
1. Check the engine oil level. Replenish if necessary. Refer to LU-25,
"Inspection".
2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection".
3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid
temperature is 50 t ...
Assembly and Installation
• Use torque wrench to tighten bolts or nuts to specification.
• When tightening nuts and bolts, as a basic rule, equally tighten in several
different steps starting with the
ones in center, then ones on inside and outside diagonally in this order. If the
order of tightening is specified,
do ...