Nissan Juke Service and Repair Manual : Removal and Disassembly
• When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations.
• Exercise maximum care to avoid damage to mating or sliding surfaces.
• Dowel pins are used for several parts alignment. When replacing and reassembling parts with dowel pins, check that dowel pins are installed in the original position.
• Cover openings of engine system with a tape or equivalent, if necessary, to seal out foreign materials.
• Mark and arrange disassembly parts in an organized way for easy troubleshooting and reassembly.
• When loosening nuts and bolts, as a basic rule, start with the one furthest outside, then the one diagonally opposite, and so on. If the order of loosening is specified, do exactly as specified. Power tools may be used in the step.
Disconnecting Fuel Piping
• Before starting work, check no fire or spark producing items are in the work area. • Release fuel pressure before disconnecting and disassembly. • After disconnecting pipes, plug openings to sto ...Inspection, Repair and Replacement
Before repairing or replacing, thoroughly inspect parts. Inspect new replacement parts in the same way, and replace if necessary. ...Other materials:
P1551, P1552 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...
4WD warning lamp does not turn on
Description
4WD warning lamp does not turn ON when the ignition switch is turned to ON.
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Perform the trouble diagnosis for 4WD warning lamp. Refer to DLN-80,
"Diagnosis Procedure".
Is the inspection result normal?
YES >> Check eac ...
C1142 press sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...