Nissan Juke Service and Repair Manual : Remote keyless entry receiver
Removal and Installation
REMOVAL
1. Remove the glove box assembly. Refer to IP-13, "Removal and Installation".
2. Remove the remote keyless entry receiver (1) mounting bolt (A), and then remove remote keyless entry receiver.
INSTALLATION
Install in the reverse order of removal.
Door switch
Exploded View 1. Door switch 2. TORX bolt Removal and Installation REMOVAL Remove the TORX bolt (A), and then remove door switch (1). INSTALLATION Install in the reverse order of removal. ...Keyfob battery
Exploded View 1. Upper case 2. Key 3. Switch cover 4. Switch rubber 5. Board surface 6. Battery 7. plate 8. Lower case 9. Screw Removal and Installation REMOVAL 1. Remove screw (9) ...Other materials:
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
applications. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Modern
vehicle is equipped with many electronic control unit, and eac ...
Precaution for Brake Control system
• Always perform a pre-driving check to drive the vehicle.• Always perform a
pre-driving check to drive the vehicle.
• Always check speed and safety while driving the vehicle.
• Always check speed and safety while driving the vehicle.
• To operate CONSULT-III while driving, more than one pers ...
P0037, P0038 HO2S2 heater
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...