Nissan Juke Service and Repair Manual : Refilling

1. Remove filler plug (1) and gasket from transaxle case.

2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure.

Oil grade and viscosity : Refer to MA-13, "Fluids and Lubricants".

Oil capacity : Refer to TM-63, "General Specifications

3. After refilling gear oil, check the oil level. Refer to TM-22, "Inspection".

4. Set a gasket on filler plug and then install it to transaxle case.

CAUTION:
Never reuse gasket.

5. Tighten filler plug to the specified torque. Refer to TM-33, "Exploded View".

Removal and installation


    Draining
    1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. 3. Set a gasket on drain plu ...

    Other materials:

    Additional service when removing battery negative terminal
    Description • The audio unit is equipped with the anti-theft system. • The audio unit operates after authenticating a fixed four-digit anti-theft code. • After removing the battery of the audio unit, the authentication of the anti-theft code is required. Work Procedure 1.POWER SWITCH ON 1. ...

    Precaution for Seat Belt Service
    CAUTION: • Before removing the front seat belt pre-tensioner assembly, turn the ignition switch off, disconnect battery negative terminal and wait at least 3 minutes. • Do not use electrical test equipment for front seat belt pre-tensioner connector. • After replacing or reinstalling front s ...

    B2623 inside antenna
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode. 3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK SUPPORT” of “INTELL ...