Nissan Juke Service and Repair Manual : Refilling
1. Remove filler plug (1) and gasket. Then fill oil up to mounting hole for the filler plug.
: Vehicle front
Oil and viscosity : Refer to MA-13, "Fluids and Lubricants".
Oil capacity : Refer to DLN-117, "General Specifications".
CAUTION:
Carefully fill the oil. (Fill up for approximately 3 minutes.)
2. Leave the vehicle for 3 minutes, and check the oil level again.
3. Before installing filler plug, set a new gasket. Install filler plug on transfer and tighten to the specified torque. Refer to DLN-113, "Exploded View".
CAUTION:
Never reuse gasket.
Draining
1. Run the vehicle to warm up the transfer unit sufficiently. 2. Stop the engine and remove the drain plug (1) and gascket to drain the transfer oil. 3. Before installing drain plug, set a new gask ...Other materials:
Radiator : Inspection
Check radiator for mud or clogging. If necessary, clean radiator as follows.
CAUTION:
• Be careful not to bend or damage radiator fins.
• When radiator is cleaned without removal, remove all surrounding parts such as
radiator cooling fan
assembly and horns. Then tape harness and harness conn ...
System
Engine control system : System Diagram
Engine control system : System Description
ECM performs various controls such as fuel injection control and ignition
timing control.
MULTIPORT FUEL INJECTION SYSTEM
Multiport fuel injection system : System Diagram
Multiport fuel injection system : ...
Roof side molding
Exploded View
1. Roof side molding
2. Roof side molding clip
3. Double-sided tape [t: 2.5 mm (0.098 in)]
4. Body side outer panel
5. Roof panel
: Vehicle front
: Do not reuse
Removal and Installation
REMOVAL
ROOF SIDE MODLDING
1. Disengage roof side molding rear side fixing clip, usi ...