Nissan Juke Service and Repair Manual : Rear oil seal
REAR OIL SEAL : Removal and Installation
REMOVAL
1. Remove transaxle assembly. Refer to TM-301, "Exploded View" (CVT models) or TM-84, "MR16DDT : Exploded View" (M/T models).
2. Remove clutch cover and clutch disk (M/T models). Refer to CL-29, "EXCEPT FOR K9K : Exploded View".
3. Remove drive plate (CVT models) or flywheel (M/T models). Refer to EM-103, "Exploded View".
4. Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage crankshaft and cylinder block.
INSTALLATION
1. Apply the liquid gasket lightly to entire outside area of new rear oil seal.
Use Genuine Liquid Gasket or equivalent.
2. Install rear oil seal so that each seal lip is oriented as shown in the figure.
A : Dust seal lip
B : Oil seal lip
: Engine outside
: Engine inside
• Press-fit rear oil seal with a suitable drift (A) outer diameter 115 mm (4.53 in) and inner diameter 90 mm (3.54 in).
CAUTION:
• Be careful not to damage crankshaft and cylinder block.
• Press-fit oil seal straight to avoid causing burrs or tilting.
• Never touch grease applied onto oil seal lip.
• Press in rear oil seal (1) to the position as shown in the figure.
A : Rear end surface of cylinder block
3. Install in the reverse order of removal, for the rest of parts.
Front oil seal
FRONT OIL SEAL : Removal and Installation REMOVAL 1. Remove the following parts. • Front fender protector (RH): Refer to EXT-22, "Exploded View". • Drive belt: Refer to EM-20, "Expl ...Cylinder head
Exploded View REMOVAL 1. Cylinder head assembly 2. Cylinder head bolt 3. Cylinder head gasket A. Tightening must be done following the installation procedure. Refer to EM-91 : N·m (kg-m, ...Other materials:
C1144 incomplete steering angle sensor adjustment
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
Service Notice or Precautions for Transfer
• After overhaul refill the transfer with new transfer oil.
• Check the oil level or replace the oil only with the vehicle parked on level
surface.
• During removal or installation, keep inside of transfer clear of dust or
dirt.
• Replace all tires at the same time. Always use tires of the pr ...
Periodic maintenance
Periodic Maintenance
The following tables show the normal maintenance schedule. Depending upon
weather and atmospheric conditions,
varying road surfaces, individual driving habits and vehicle usage, additional
or more frequent maintenance
may be required.
Periodic maintenance beyond the la ...