Nissan Juke Service and Repair Manual : Rear door speaker
Removal and Installation
REMOVAL
1. Remove rear door finisher. Refer to INT-16, "Exploded View".
2. Remove rear door speaker screws, then disconnect rear door speaker connector and remove rear door speaker.
INSTALLATION
Install in the reverse order of removal.
Tweeter
Removal and Installation REMOVAL 1. Remove front pillar garnish. Refer to INT-18, "Exploded View". 2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter. INSTALL ...Antenna base
Exploded View 1. Antenna rod 2. Antenna base : N·m (kg-m, in-lb) Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Disconnect antenna feed ...Other materials:
P0078 EVT control solenoid valve
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Rear door lock
Exploded View
1. Outside handle assembly
2. Inside handle
3. TORX bolt
4. Door lock assembly
5. Rear door sealing screen
: Clip
: Pawl
: Vehicle front
: Do not reuse
: N·m (kg-m, in-lb)
: Body grease
Door lock
DOOR LOCK : Removal and Installation
REMOVAL
1. Remove rear door glass ...
C1116 stop lamp switch
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...