Nissan Juke Service and Repair Manual : Rear Axle 2WD
- Preparation
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Service data and specifications (SDS)
Service data and specifications (SDS)
Wheel Bearing
Drive Shaft
*: For measuring position, refer to FAX-81, "WHEEL SIDE : Disassembly and
Assembly" (Wheel side), FAX-
84, "TRANSAXLE SIDE : Disassembly and Assembly& ...
Preparation
Commercial Service Tools
...
Other materials:
P0087 fuel pump
DTC Logic
DTC DETECTION LOGIC
NOTE:
• Conditions for applying the diagnostic procedure to the stored DTCs:
The DTC becomes present during the first 30 seconds after the engine starts.
• In low ambient temperature conditions, diagnostic cannot make difference
between a normal long engine ...
P0444 EVAP canister purge volume control solenoid valve
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure ...
Warning and indicator lights
Warning/Indicator light (red)
12-volt battery charge warning light
or
Brake warning light
Electric shift control system warning light
or
Electro ...
