Nissan Juke Owners Manual : Push-button ignition switch positions

LOCK (Normal parking position)

The ignition switch can only be locked in this position.

The ignition switch will be unlocked when it is pushed to the ACC position while carrying the Intelligent Key.

ACC (Accessories)

This position activates electrical accessories such as the radio, when the engine is not running.

ON (Normal operating position)

This position turns on the ignition system and electrical accessories.

OFF

The engine can be turned off in this position.

Continuously Variable Transmission models: The ignition lock is designed so that the ignition switch cannot be switched to the LOCK position until the shift lever is moved to the P (Park) position.

CAUTION

Do not leave the vehicle with the pushbutton ignition switch in ACC or ON position when the engine is not running for an extended period. This can discharge the battery.

    Push-button ignition switch operation
    When the ignition switch is pushed without depressing the brake pedal (Continuously Variable Transmission models) or the clutch pedal (manual transmission models), the ignition switch position w ...

    Emergency engine shut off
    To shut off the engine in an emergency situation while driving, perform the following procedure: • Rapidly push the push-button ignition switch 3 consecutive times in less than 1.5 seconds, or • ...

    Other materials:

    Removal and installation
    POWER SOCKET Exploded View 1 : Inner socket 2 : Ring Removal and Installation REMOVAL 1. Remove cluster tray. Refer to IP-13, "Removal and Installation". 2. Pull out inner socket (1) by pushing the pawl (B) of the ring (2) from the inner socket hole (square) (A). 3. Press the ...

    Front oil seal
    FRONT OIL SEAL : Removal and Installation REMOVAL 1. Remove the following parts. • Front fender protector (RH): Refer to EXT-22, "Exploded View". • Drive belt: Refer to EM-20, "Exploded View". • Crankshaft pulley: Refer to EM-67, "Exploded View". 2. Remove front ...

    Heater control
    Exploded View 1. Intake door cable 2. Air mix door cable 3. Mode door cable 4. Heater control 5. Intake door lever knob A. To intake door link B. To air mix door link C. To mode door link Removal and Installation REMOVAL 1. Remove A/C finisher. Refer to IP-13, "Removal and Ins ...