Nissan Juke Owners Manual : Push-button ignition switch (models with Intelligent Key system)

Nissan Juke Owners Manual / Starting and driving / Push-button ignition switch (models with Intelligent Key system)

WARNING

Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops while the vehicle is being driven, this could lead to a crash and serious injury.

Before operating the push-button ignition switch, be sure to move the shift lever to the P (Park) position (for Continuously Variable Transmission models) or the shift lever to the N (Neutral) position (for manual transmission models).

Key positions
LOCK (0) The key can only be removed from the ignition switch at this position. OFF (1) The engine is turned off. The power supply is turned off. ACC (2) The electrical accessory power activates ...

Operating range for engine start function
The Intelligent Key can only be used for starting the engine when the Intelligent Key is within the specified operating range1 . When the Intelligent Key battery is almost discharged or strong ra ...

Other materials:

P1554 battery current sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM COMPONENT FUNCTION CHECK Perform component function check. Refer to EC-709, "Component Function Check". NOTE: Use component function check to check the overall function of the battery current sensor circuit. D ...

Precaution
Precautions for Suspension • When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil. - Unladen conditions mean that fuel, engine coolant ...

B1215, B1216, B1217 satellite sensor LH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...