Nissan Juke Service and Repair Manual : Push-button ignition switch
Removal and Installation
REMOVAL
1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation".
2. Remove the push-button ignition switch.
1. Disengage the push-button ignition switch fixing pawls using minus driver etc.
2. Press the push-button ignition switch to remove it from cluster lid A (2).
: Pawl
INSTALLATION
Install in the reverse order of removal.
Nats antenna AMP
Removal and Installation REMOVAL 1. Remove the cluster lid A. Refer to IP-13, "Removal and Installation". 2. Remove the NATS antenna amp. 1. Disengage the NATS antenna amp. (1) fixing ...Other materials:
Precaution for Brake System
WARNING:
Clean any dust from the front brake and rear brake with a vacuum dust collector.
Never blow with compressed
air.
• Brake fluid use refer to MA-13, "Fluids and Lubricants".
• Never reuse drained brake fluid.
• Never spill or splash brake fluid on painted surfaces. Brake flui ...
Front door glass
Exploded View
1. Front door panel
2. Lower sash (front)
3. Sealing screen
4. Pull handle bracket
5. Front door glass run
6. Front door glass
7. Power window motor
8. Front door regulator assembly
9. Lower sash (rear)
: Vehicle front
Removal and Installation
REMOVAL
1. Fully open ...
P0327, P0328 KS
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...