Nissan Juke Service and Repair Manual : Preparation
Commercial Service Tools
Work
• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operational. • Check the lubrication level, damage, and wear of each part. If nec ...Other materials:
Service Notice
• When removing or installing various parts, place a cloth or padding onto
the vehicle body to prevent
scratches.
• Handle trim, molding, instruments, grille, etc. carefully during removing or
installing. Be careful not to oil or
damage them.
• Apply sealing compound where necessary when ins ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
4WD branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (unit side and connector
side).
- 4WD control module
- Harness connecoto ...