Removal and Installation Procedure for CVT Unit Connector

REMOVAL • Rotate bayonet ring (A) counterclockwise. Pull out CVT unit harness connector (B) upward and remove it. INSTALLATION 1. Align marking (A) on CVT unit harness connector terminal with m ...

Special Service Tools

*: The O-ring as an unit part is set as a SST. ...

Other materials:

Operation inspection
Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK MEMORY FUNCTION 1. Set temperature to 30°C by operating the temperature control dial. 2. Press OFF switch. 3 ...

Loading tips
•  The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./ C.M.V.S.S. certification label. • Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. WARNING •  Properly secure all cargo with ropes or straps to help prevent it from sliding or shif ...

A/C control
Exploded View 1. Intake door cable 2. Mode door cable 3. A/C control 4. Air mix door cable 5. Intake door lever knob A. To mode door link B. To intake door link C. To air mix door link Removal and Installation REMOVAL 1. Remove A/C finisher. Refer to IP-13, "Removal and Install ...