Nissan Juke Owners Manual : Precautions on cruise control
• If the cruise control system malfunctions, it will cancel automatically. The CRUISE indicator light on the meter panel will then blink to warn the driver.
• If the engine coolant temperature becomes excessively high, the cruise control system will cancel automatically.
• If the CRUISE indicator light blinks, turn the cruise control MAIN switch off and have the system checked by a NISSAN dealer.
• The CRUISE indicator light may blink when the cruise control MAIN switch is turned ON while pushing the ACCEL/RES, COAST/ SET or CANCEL switch. To properly set the cruise control system, perform the following procedures.
WARNING
Do not use the cruise control when driving under the following conditions:
• when it is not possible to keep the vehicle at a set speed • in heavy traffic or in traffic that varies in speed • on winding or hilly roads • on slippery roads (rain, snow, ice, etc.) • in very windy areas
Doing so could cause a loss of vehicle control and result in an accident.
CAUTION
On Manual Transmission (MT) models, do not shift into N (Neutral) without depressing the clutch pedal when the cruise control is set. Should this occur, depress the clutch pedal and turn the MAIN switch off immediately. Failure to do so may cause engine damage.
Cruise control
...Cruise control operations
1. ACCEL/RES switch 2. COAST/SET switch 3. CANCEL switch 4. MAIN (ON·OFF) switch The cruise control allows driving at a speed between 25 to 89 MPH (40 to 144 km/h) without keeping your foot on ...Other materials:
Malfunction indicator
Component Function Check
1.CHECK MI FUNCTION
1. Turn ignition switch ON.
2. Make sure that MI lights up.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to EC-1019, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK CAN COMMUNICATION LINE
Refer to LAN ...
Component parts
Component Parts Location
1. Hazard switch
2. Parking lamp
3. Front turn signal lamp
4. Front fog lamp*1
5. Headlamp
6. ECM
Refer to EC-461, "ECM".
7. IPDM E/R
Refer to PCS-5, "Component Parts
Location".
8. BCM
Refer to BCS-6, "BODY CONTROL
SYSTEM : Compone ...
Idle air volume learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume
that keeps each engine idle speed
within the specific range. It must be performed under any of the following
conditions:
• Each time electric throttle control actuator or ECM is replaced.
• Idle speed or ...