Nissan Juke Service and Repair Manual : Precautions for Drive Shaft

• Observe the following precautions when disassembling and assembling drive shaft.

- Never disassemble joint sub-assembly because it is non-overhaul parts.

- Perform work in a location which is as dust-free as possible.

- Clean the parts, before disassembling and assembling.

- Prevent the entry of foreign objects during disassembly of the service location.

- Reassemble disassembled parts carefully in the correct order. If work is interrupted, a clean cover must be placed over parts.

- Use paper waste. Fabric shop cloths must not be used because of the danger of lint adhering to parts.

- Clean disassembled parts (except for rubber parts) with kerosene which shall be removed by blowing with air or wiping with paper waste

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

    Other materials:

    Blower motor
    Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >>GO TO 2. B >>GO TO 7. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 15A fuses (Nos. 14 and 16, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector and T ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver a ...

    Center console assembly
    Exploded View CVT models 1. Console indicator finisher 2. Instrument lower cover RH 3. Center console assembly 4. Instrument lower cover LH 5. Instrument stay 6. CVT shift selector assembly 7. Console rear bracket 8. Console rear finisher 9. Seat heated switch 10. Console switch f ...