Nissan Juke Service and Repair Manual : Precautions for Drive Shaft

• Observe the following precautions when disassembling and assembling drive shaft.

- Never disassemble joint sub-assembly because it is non-overhaul parts.

- Perform work in a location which is as dust-free as possible.

- Clean the parts, before disassembling and assembling.

- Prevent the entry of foreign objects during disassembly of the service location.

- Reassemble disassembled parts carefully in the correct order. If work is interrupted, a clean cover must be placed over parts.

- Use paper waste. Fabric shop cloths must not be used because of the danger of lint adhering to parts.

- Clean disassembled parts (except for rubber parts) with kerosene which shall be removed by blowing with air or wiping with paper waste.

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

    Other materials:

    Basic inspection
    1.INSPECTION START 1. Check service records for any recent repairs that may indicate a related malfunction, or a current need for scheduled maintenance. 2. Open engine hood and check the following: - Harness connectors for improper connections - Wiring harness for improper connections, pinche ...

    Thermo control amplifier
    Removal and Installation REMOVAL 1. Remove evaporator. Refer to HA-115, "EVAPORATOR : Removal and Installation". 2. Remove thermo control amp. from evaporator. INSTALLATION Note the following items, and then install in the reverse order of removal. CAUTION: • Replace O-ring wi ...

    Vehicle speed sensing auto lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Refer to DLK-41, "DOOR LOCK : ...