Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

Handling for Adhesive and Primer

• Never use an adhesive that is past its usable date. Shelf life of this product is limited to six months after the date of manufacture. Carefully adhere to the expiration or manufacture date pri ...

Other materials:

L terminal circuit (open)
Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warning la ...

Compression pressure
Inspection 1. Warm up engine thoroughly. Then, stop it. 2. Release fuel pressure. Refer to EC-551, "Work Procedure". 3. Remove ignition coil and spark plug from each cylinder. Refer to EM-53, "Exploded View". 4. Connect engine tachometer (not required in use of CONSULT-II ...

Excessive consumption
Description CHART 15:EXCESSIVE CONSUMPTION Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace ha ...