Nissan Juke Service and Repair Manual : Precaution for G Sensor Removal/Installation or Replacement
CAUTION:
To remove/install or replace G sensor, refer to TM-182, "Description".
Precaution for TCM and Transaxle Assembly Replacement
CAUTION: • To replace TCM, refer to TM-178, "Description". • To replace transaxle assembly, refer to TM-180, "Description". ...Removal and Installation Procedure for CVT Unit Connector
REMOVAL Rotate bayonet ring (1) counterclockwise, pull out CVT unit harness connector (2) upward and remove it. INSTALLATION 1. Align Δ marking on CVT unit harness connector terminal body ...Other materials:
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
Vehicle security system cannot BE set
INTELLIGENT KEY
INTELLIGENT KEY : Description
Armed phase is not activated when door is locked using Intelligent Key.
NOTE:
Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE
(OPERATING CONDITIONS)”
before starting diagnosis, and check each symptom.
CONDITION OF VE ...
Information display (speed limiter)
Component Function Check
1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION
1. Start engine.
2. Press speed limiter MAIN switch.
3. Drive the vehicle at more than 30 km/h (20 MPH).
CAUTION:
Always drive vehicle at a safe speed.
4. Press SET/− switch.
5. Perform a test drive on a fl ...