Nissan Juke Service and Repair Manual : Precaution for Brake System

WARNING:
Clean any dust from the front brake and rear brake with a vacuum dust collector. Never blow with compressed air.

• Brake fluid use refer to MA-13, "Fluids and Lubricants".

• Never reuse drained brake fluid.

• Never spill or splash brake fluid on painted surfaces. Brake fluid may seriously damage paint. Wipe it off immediately and wash with water if it gets on a painted surface. For brake component parts, never wash them with water.

• Always confirm the specified tightening torque when installing the brake pipes.

• After pressing the brake pedal more deeply or harder than normal driving, such as air bleeding, check each item of brake pedal. Adjust brake pedal if it is outside the standard value.

• Always clean with new brake fluid when cleaning the master cylinder, brake caliper and other components.

• Never use mineral oils such as gasoline or light oil to clean. They may damage rubber parts and cause improper operation.

• Always loosen the brake tube flare nut with a flare nut wrench.

• Tighten the brake tube flare nut to the specified torque with a flare nut torque wrench (A).

• Turn the ignition switch OFF and disconnect the ABS actuator and electric unit (control unit) harness connector or the battery negative terminal before performing the work.

• Check that no brake fluid leakage is present after replacing the parts.

• Burnish the brake contact surfaces after refinishing or replacing rotors, after replacing pads, or if a soft pedal occurs at very low mileage.

- Front brake pad: Refer to BR-16, "BRAKE PAD : Inspection and Adjustment".

- Front disc rotor: Refer to BR-16, "DISC ROTOR : Inspection and Adjustment".

- Rear brake pad: Refer to BR-18, "BRAKE PAD : Inspection and Adjustment".

- Rear disc rotor: Refer to BR-18, "DISC ROTOR : Inspection and Adjustment".


- Rear disc rotor: Refer to BR-18, "DISC ROTOR : Inspection and Adjustment".

    Precaution for Procedure without Cowl Top Cover
    When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc. ...

    Preparation
    Commercial Service Tool ...

    Other materials:

    Operating tips
    • When the shift lever is shifted to the R (Reverse) position, the monitor screen automatically changes to the RearView Monitor mode. However, the radio can be heard. • When the view is switched, the display images on the screen may be displayed with some delay. • When the temperature is extre ...

    Can communication
    CAN COMMUNICATION : System Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped ...

    Driver side door mirror defogger
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check 1.CHECK DRIVER SIDE DOOR MIRROR DEFOGGER 1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III. 2. Touch “ON”. 3. C ...