Engine Lubrication System K9K

...

Liquid Gasket

REMOVAL OF LIQUID GASKET • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100] (A) and remove old liquid gasket sealing. CAUTION: Be care ...

Other materials:

Unit removal and installation
TRANSMISSION ASSEMBLY Exploded View 1. Transaxle assembly A: : For the tightening torque, refer to TM-508, "Removal and Installation". Removal and Installation REMOVAL WARNING: Never open the radiator cap or drain plug when the engine is hot. Hot liquid may spray out, causing s ...

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden ...

Key switch
Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEY ON SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Key switch is OK. N ...