Nissan Juke Service and Repair Manual : Precaution

Precautions for Suspension

• When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil.

- Unladen conditions mean that fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.

• After servicing suspension parts, be sure to check wheel alignment.

• Self-lock nuts are not reusable. Always use new ones when installing. Since new self-lock nuts are pre-oiled, tighten as they are.

• The tightening surface must be kept free of oil/grease.

• When jacking up the vehicle with a floor jack, never hang the jack on the suspension beam.

    Symptom diagnosis
    NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

    Other materials:

    Insufficient heating
    Description Symptom • Insufficient heating • No warm air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. 1.CHE ...

    Door motor
    Exploded View LEFT SIDE 1. A/C unit assembly 2. Intake door lever 3. Intake door motor 4. Air mix door motor 5. Upper air mix door rod 6. Upper air mix door lever 7. Lower air mix door lever 8. Lower air mix door rod RIGHT SIDE 1. A/C unit assembly 2. Main link 3. Sub defrost ...

    Oil pan (lower)
    Exploded View 1. O-ring 2. Oil pan (upper) 3. Oil level gauge guide 4. O-ring 5. Oil level gauge 6. Oil pump drive chain 7. Crankshaft sprocket 8. Oil pump sprocket 9. Oil pump chain tensioner 10. Oil pump 11. Drain plug 12. Drain plug washer 13. Oil pan (lower) 14. Oil fil ...