Nissan Juke Service and Repair Manual : Power Window Control System
- Precaution
- System description
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- Diagnosis and repair work flow
- Additional service when removing battery negative terminal
- Additional service when replacing control unit
- System initialization
- Check anti-pinch function
- DTC/circuit diagnosis
- Power supply and ground circuit
- Front power window switch (passenger side)
- Rear power window switch
- Power window motor
- Encoder circuit
- Symptom diagnosis
- None of the power windows can be operated using any switch
- Driver side power window does not operate
- Auto operation does not operate but manual operate normally (driver side)
- Anti-pinch system does not operate normally (driver side)
- Power window lock switch does not function
- Removal and installation
Rear regulator
Exploded View 1. Rear door panel 2. Sealing screen 3. Lower sash (front) 4. Rear door regulator assembly 5. Power window motor 6. Rear door glass 7. Lower sash (rear) 8. Rear door glass ...Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, us ...Other materials:
Coil spring
Exploded View
1. Upper rubber seat
2. Coil spring
3. Lower rubber seat
4. Rear suspension beam
Removal and Installation
REMOVAL
1. Remove tires. Refer to WT-7, "Removal and Installation".
2. Set jack under rear suspension beam.
CAUTION:
• Never damage the suspension beam wi ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
B terminal circuit
Description
“B” terminal circuit supplies power to charge the battery and to operate the
vehicle’s electrical system.
Diagnosis Procedure
1.CHECK “B” TERMINAL CONNECTION
1. Turn ignition switch OFF.
2. Check if “B” terminal is clean and tight.
Is the inspection result normal?
YES >> ...