Nissan Juke Service and Repair Manual : Power transistor

Exploded View

1. A/C unit assembly


1. A/C unit assembly 2. Blower fan resistor*1 3. Sub harness*1
4. Power transistor*2
5. Sub harness*2
6. Blower motor

• *1: Manual air conditioner • *2: Automatic air conditioner

Removal and Installation

REMOVAL

1. Remove instrument panel assembly. Refer to IP-13, "Removal and Installation". (LHD models) 2. Remove glove box assembly. Refer to IP-13, "Removal and Installation". (RHD models)
3. Disconnect power transistor connector.

4. Slide power transistor (1) to the left while pressing lever (A), and then remove power transistor.

INSTALLATION


INSTALLATION

Install in the reverse order of removal.

    Refrigerant pressure sensor
    Exploded View Refer to HA-94, "Exploded View". Removal and Installation REMOVAL Refer to HA-96, "REFRIGERANT PRESSURE SENSOR : Removal and Installation". INSTALLATION Insta ...

    Door motor
    Exploded View LEFT SIDE 1. A/C unit assembly 2. Intake door lever 3. Intake door motor 4. Air mix door motor 5. Upper air mix door rod 6. Upper air mix door lever 7. Lower air mix door l ...

    Other materials:

    System
    4WD system : System Diagram INPUT/OUTPUT SIGNAL It transmits/receives each signal from the following 4WD control module via CAN communication line. 4WD system : System Description • 4WD mode is selectable among 2WD, 4WD-V, and 4WD by operating the 4WD mode switch. • When judging drivi ...

    P0444 EVAP canister purge volume control solenoid valve
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following procedure ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of the customer's comments; refer to MIR-39, & ...