Nissan Juke Service and Repair Manual : Power Supply, Ground & Circuit Elements
- Precaution
- System description
- Wiring diagram
- Power supply routing circuit
- Option harness
- Fuse block - junction box (J/B)
- Fuse, fusible link and relay box
- IPDM E/R (intelligent power distribution module engine room)
- Harness layout
- Connector information
- Basic inspection
- Removal and installation
- Service data and specifications (SDS)
Service data and specifications (SDS)
Alternator *: Adjustment range of power generation voltage variable control is 11.4 − 15.6 V. ...Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, ...Other materials:
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
Diagnosis system (IPDM E/R)
Diagnosis Description
AUTO ACTIVE TEST
Description
In auto active test mode, the IPDM E/R sends a drive signal to the following
systems to check their operation.
• Oil pressure warning lamp (only for K9K engine models)
• Rear window defogger
• Front wiper motor
• Parking lamp
• License p ...
General Specification
CAUTION:
• Use only Genuine NISSAN CVT Fluid NS-2. Never mix with other fluid.
• Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in
driveability and CVT durability, and may damage
the CVT, which is not covered by the warranty.
*1: Refer to MA-13, "Fluids and Lu ...