Nissan Juke Service and Repair Manual : Power supply and ground circuit

Diagnosis Procedure

1.CHECK FUSES AND FUSIBLE LINK

Check that the following IPDM E/R fuses or fusible links are not blown.

Is the fuse fusing?


Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown.

NO >> GO TO 2.

2.CHECK POWER SUPPLY CIRCUIT

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R connector.

3. Check voltage between IPDM E/R harness connector and the ground.

Is the measurement value normal?


Is the measurement value normal? YES >> GO TO 3.

NO >> Repair the harness or connector.

3.CHECK GROUND CIRCUIT

Check continuity between IPDM E/R harness connectors and the ground.

Does continuity exist?


Does continuity exist? YES >> INSPECTION END

NO >> Repair the harness or connector.

    B2099 ignition relay off stuck
    Description The ignition relay integrated in IPDM E/R is operated with ignition switch ON signal from the ignition switch. DTC Logic DTC DETECTION LOGIC NOTE: When IPDM E/R power supply volta ...

    Removal and installation
    IPDM E/R Exploded View 1. IPDM E/R cover A 2. IPDM E/R 3. IPDM E/R cover B Removal and Installation IPDM E/R integrated relays are not serviceable parts, and must not be removed from the un ...

    Other materials:

    System
    System Description • The system switches fluid pressure of each brake caliper to increase, to hold or to decrease according to signals from control unit in ABS actuator and electric unit (control unit). This control system is applied to ESP function, TCS function, ABS function, EBD function a ...

    Cylinder block
    Exploded View 1. Cylinder block 2. Top ring 3. Second ring 4. Oil ring 5. Piston 6. Piston pin 7. Snap ring 8. Connecting rod 9. Connecting rod bearing (upper) 10. Connecting rod bearing (lower) 11. Crankshaft key 12. Connecting rod cap 13. Connecting rod cap bolt 14. Main ...

    Inspection
    OIL LEAKAGE Check transfer surrounding area (oil seal, drain plug, filler plug, and transfer case etc.) for oil leakage. OIL LEVEL 1. Remove filler plug (1) and gasket. Then check that oil is filled up from mounting hole for the filler plug. Vehicle front CAUTION: Never start engine while ...