Nissan Juke Owners Manual : Power outlet

The power outlet is located in the instrument panel.


The power outlet is located in the instrument panel.

CAUTION

• The outlet and plug may be hot during or immediately after use.

• Do not use with accessories that exceed a 12 volt, 120W (10A) power draw. Do not use double adapters or more than one electrical accessory.

•  Use power outlet with the engine running to avoid discharging the vehicle battery.

• Avoid using power outlet when the air conditioner, headlights or rear window defroster is on.

• This power outlet is not designed for use with a cigarette lighter unit.

• Push the plug in as far as it will go.

If good contact is not made, the plug may overheat or the internal temperature fuse may open.

• Before inserting or disconnecting a plug, be sure the electrical accessory being used is turned OFF.

• When not in use, be sure to close the cap. Do not allow water or any liquid to contact the outlet.

    Clock (if so equipped)
    The digital clock (in the audio unit) displays time when the ignition switch is in the ACC or ON position. The clock ON or OFF mode can be selected. For details of the digital clock in the NAVIGAT ...

    Storage
    ...

    Other materials:

    Push-button ignition switch
    Component Function Check 1.CHECK FUNCTION 1. Select “PUSH SW” in “Data Monitor” mode with CONSULT-III. 2. Check the push-button ignition switch signal under the following conditions. Is the indication normal? YES >> INSPECTION END. NO >> Go to PCS-108, "Diagnosis Procedure&q ...

    Engine oil
    Inspection ENGINE OIL LEVEL NOTE: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before checking. 1. Pull out oil level gauge and wipe it clean. 2. Insert oil level gauge and check that the engine ...

    SRS air bag warning lamp does not turn on
    Diagnosis Procedure 1.CHECK COMBINATION METER POWER SUPPLY AND GROUND CIRCUIT Check conbination meter unit power supply and ground circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or r ...