Nissan Juke Service and Repair Manual : Position switch

Removal and Installation

REMOVAL

1. Remove air cleaner case. (K9K) Refer to EM-280, "Removal and Installation".

2. Remove battery. (MR16DDT) Refer to PG-124, "Removal and Installation".

3. Disconnect position switch connector.

4. Remove position switch from transaxle case.

INSTALLATION

1. Apply recommended sealant to threads of position switch.

• Use Genuine Liquid Gasket, Three Bond 1215 or an equivalent.

CAUTION:
Remove old sealant and oil adhering to threads.

2. Install position switch to transaxle case.

3. Tighten position switch to the specified torque. Refer to TM-88, "Exploded View".

4. For the next step and after, install in the reverse order of removal.

Inspection

INSPECTION AFTER INSTALLATION

• Check continuity between position switch terminals. Refer to TM-73, "BACK-UP LAMP SWITCH : Component Inspection" (Back-up lamp switch) and TM-73, "PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection" (PNP switch).

• Check the oil leakage. Refer to TM-75, "Inspection".

    Side oil seal
    Removal and Installation REMOVAL 1. Remove front drive shafts. (MR16DDT) Refer to FAX-22, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-24, "RIGHT SIDE : Removal and I ...

    Control linkage
    Exploded View 1. Bracket 2. Shifter cable 3. Selector lever 4. Shifter lever A 5. Tapping bolt 6. Cable mounting bracket 7. Selector cable 8. Grommet 9. M/T shift selector assembly 1 ...

    Other materials:

    Insufficient heating
    Description Symptom • Insufficient heating • No warm air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnoses with CONSULT-III before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis. 1.CHECK COOLING SYSTEM 1. ...

    Interior room lamp control system
    Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation: if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    B260B steering lock unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ignition switch OFF. 3. Press driver side door switch. 4. Shift selector lever to the P position. 5. Press push-button ignition switch under the following condi ...