Nissan Juke Service and Repair Manual : Position switch
Removal and Installation
REMOVAL
1. Drain gear oil. Refer to TM-22, "Draining".
2. Disconnect position switch connector (A).
3. Remove position switch from transaxle case.
INSTALLATION
1. Apply recommended sealant to threads of position switch.
• Use Genuine Liquid Gasket, Three Bond 1215 or an equivalent.
CAUTION:
Remove old sealant and oil adhering to threads.
2. Install position switch to transaxle case.
3. Tighten position switch to the specified torque. Refer to TM-33, "Exploded View".
4. Refill gear oil. Refer to TM-22, "Refilling".
Inspection
INSPECTION AFTER INSTALLATION
• Check continuity between position switch terminals. Refer to TM-20, "BACK-UP LAMP SWITCH : Component Inspection" (Back-up lamp switch) and TM-20, "PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection" (PNP switch).
• Check the oil leakage and the oil level. Refer to TM-22, "Inspection".
Side oil seal
Removal and Installation REMOVAL 1. Remove front drive shafts. Refer to FAX-53, "Removal and Installation". 2. Remove differential side oil seals (1) from clutch housing and transaxle ca ...Control linkage
Exploded View 1. Bracket 2. Selector cable 3. Shifter lever A 4. Selector lever 5. Cable mounting bracket 6. Tapping bolt 7. Shifter cable 8. Grommet 9. M/T shift selector assembly 1 ...Other materials:
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer
>> GO TO 2.
2.SYMPTOM CHECK
Check the symptom from the customer's information. Check that any symptom
occurs other than the interviewed
symptom.
Insufficient cooling/heat ...
B1212, B1213, B1214 satellite sensor RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Diagnosis system (BCM)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the ...