Nissan Juke Service and Repair Manual : Plug

Description

Replace the O-ring if oil leakage or exudes from the plug.

Exploded View

1. Plug


1. Plug
2. O-ring
3. O-ring
4. Plug

disassembly.: Always replace after every
disassembly.

: N·m (kg-m, in-lb): N·m (kg-m, ft-lb)
: Genuine NISSAN CVT Fluid NS-2: N·m (kg-m, in-lb)
Removal and Insta: Genuine NISSAN CVT Fluid NS-2


Removal and Insta

NOTE

:
Replace the O-rings if oil leakage or exudes from the plugs.

REMOVAL

Remove the plugs and O-rings.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
• Never reuse O-ring.

• Apply Genuine NISSAN CVT Fluid NS-2 to O-ring.

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for CVT fluid leakage. Refer to TM-480, "Inspection".

ADJUSTMENT AFTER INSTALLATION

Adjust the CVT fluid level. Refer to TM-379, "Adjustment".

    Fluid cooler system
    Exploded View 1. Bracket 2. Bracket 3. Bracket 4. CVT fluid cooler 5. Clamp 6. CVT fluid cooler hose C 7. CVT fluid cooler hose B 8. CVT fluid cooler tube assembly 9. CVT fluid cooler ...

    Unit removal and installation
    TRANSMISSION ASSEMBLY Exploded View 1. Transaxle assembly A: : For the tightening torque, refer to TM-508, "Removal and Installation". Removal and Installation REMOVAL WARNING: Neve ...

    Other materials:

    P183B solenoid power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Engine oil and oil filter recommendation
    1. API certification mark 2. API service symbol Selecting the correct oil It is essential to choose the correct grade, quality, and viscosity engine oil to ensure satisfactory engine life and performance, see “Capacities and recommended fuel/lubricants” . NISSAN recommends the use of an ene ...

    Hazard reminder operation does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-141, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&q ...