Symptom diagnosis

Noise, vibration and harshnesS (NVH) Troubleshooting NVH Troubleshooting - Engine Noise Use the Chart Below to Help You Find the Cause of the Symptom 1. Locate the area where noise occurs. 2. C ...

Drive belt

Checking Drive Belts WARNING: Be sure to perform when the engine is stopped. 1. Inspect belts for cracks, fraying, wear and oil. If necessary, replace. 2. Evaluate manually if the belt is enough ...

Other materials:

P160C ECM
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON and perform the self-diagnosis. Is the DTC P160C displayed again? YES >> GO TO 2. NO &g ...

Keyfob battery
Component Function Check 1.CHECK FUNCTION Check door lock and unlock operation with keyfob button. Is the inspection result normal? YES >> Keyfob is OK. NO >> Refer to DLK-403, "Diagnosis Procedure". Diagnosis Procedure 1.CHECK KEYFOB BATTERY Check by connecting a r ...

Additional service when replacing ECM
Description When replacing ECM, this procedure must be performed. Work Procedure 1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS Refer to SEC-50, "BCM : Special Repair Requirement" (With intelligent key system), SEC-190, "BCM : Work Proce ...