Nissan Juke Service and Repair Manual : Periodic maintenance

REAR PROPELLER SHAFT

Inspection

APPEARANCE AND NOISE

• Check the propeller shaft tube surface for dents or cracks. If damaged, replace propeller shaft assembly.

• If center bearing is noisy or damaged, replace propeller shaft assembly.

VIBRATION

If vibration is present at high speed, inspect propeller shaft runout first.

1. With a dial indicator, measure propeller shaft runout at runout measuring points by rotating final drive companion flange with hands.

Propeller shaft runout : Refer to DLN-125, "Propeller Shaft Runout".

• Propeller shaft runout measuring point (Point “


• Propeller shaft runout measuring point (Point “”)
”)

Dimension A: 542 mm (21.34 in): Front


Dimension A: 542 mm (21.34 in) B: 516.5 mm (20.33 in)

2. If runout still exceeds specifications, separate propeller shaft at final drive companion flange or transfer companion flange; then change the phase between companion flange and propeller shaft by the one bolt hole at a time and install propeller shaft.

3. Check runout again. If runout still exceeds specifications, replace propeller shaft assembly.

4. Check the vibration by driving vehicle.

Removal and installation


    Symptom diagnosis
    NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applic ...

    Removal and installation
    REAR PROPELLER SHAFT ...

    Other materials:

    B2581, B2582 intake sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 141, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-142, "DTC Log ...

    B2609 steering status
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1 1. Press push-button ignition switch under the following conditions and wait 1 second or more. - Selector lever: In the P position - Brake pedal: Not depressed 2. Check DTC in “Self Diagnostic ...

    Exterior lighting system symptoms
    Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. With daytime running light system WITH DAYTIME RUNNING LIGHT ...