Nissan Juke Service and Repair Manual : Parts To Be Replaced After Removal
• All gaskets
• Flywheel bolts
• Crankshaft bearing bolts
• Camshaft pulley bolt
• Crankshaft pulley bolts
• Big end cap bolts
• Injector holder copper washers
• Fuel injection tubes
• Pipe plugs
• Belts
• Timing belt tension wheel
• Oil jets
• Turbocharger plastic pipes
Precaution for Diesel Equipment
CLEANLINESS CLEANLINESS INSTRUCTIONS WHICH MUST BE FOLLOWED WHEN WORKING ON THE HIGH PRESSURE DIRECT INJECTION SYSTEM Risks relating to contamination The system is very sensitive to contaminatio ...Installation of Thread Inserts
Threaded holes on all engine component parts can be repaired by using thread inserts. ...Other materials:
B1115 satellite sensor RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
DESCRIPTION OF TROUBLE DIAGNOSIS FLOWCHART
DETAILS OF TROUBLE DIAGNOSIS FLOWCHART
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction oc ...
Diagnosis system (navi control unit)
Diagnosis Description
On-Board Diagnosis Item
• On-board diagnosis is performed in service test mode.
• On-board diagnosis checks if the system operates normally.
Service test mode
METHOD OF STARTING
1. Start the engine.
2. Turn OFF audio.
3. While pressing the “SET UP” switch, turn th ...