Nissan Juke Service and Repair Manual : Parts Requiring Angle Tightening

• Use the angle wrench [SST: KV10112100] for the final tightening of the following engine parts:
- Cylinder head bolts
- Lower cylinder block bolts - Connecting rod cap bolts - Crankshaft pulley bolt (No the angle wrench is required as bolt flange is provided with notches for angle tightening)

• Do not use a torque value for final tightening.

• The torque value for these parts are for a preliminary step.

• Ensure thread and seat surfaces are clean and coated with engine oil.

    Assembly and Installation
    • Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ...

    Liquid Gasket
    REMOVAL OF LIQUID GASKET SEALING • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100] (A) and remove old liquid gasket sealing. CAUTION: ...

    Other materials:

    Hood switch
    Component Function Check 1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III. 2. Check “HOOD SW” indication under the following condition. Is the indication normal? YES >> Hood switch is OK. NO >> Go to SEC-155, "Diagnosis Procedure& ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    Thermo control amplifier
    Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “THERMO AMP” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result normal? YES >> ...