Nissan Juke Owners Manual : Parking/parking on hills

WARNING


WARNING

• Do not stop or park the vehicle over flammable materials such as dry grass, waste paper or rags. They may ignite and cause a fire.

• Never leave the engine running while the vehicle is unattended.

• Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls.

Unattended children could become involved in serious accidents.

• Safe parking procedures require that both the parking brake be applied and the transmission placed into P (Park) for Continuously Variable Transmission (CVT) model or in an appropriate gear for Manual Transmission (MT) model. Failure to do so could cause the vehicle to move unexpectedly or roll away and result in an accident.

• Make sure the continuously variable transmission shift lever has been pushed as far forward as it can go and cannot be moved without depressing the foot brake pedal.

1. Firmly apply the parking brake.

2. Continuously Variable Transmission (CVT) models:

Move the shift lever to the P (Park) position.

Manual Transmission (MT) models: Move the shift lever to the R (Reverse) gear.

When parking on an uphill grade, place the shift lever in the 1st gear.

3. To help prevent the vehicle from rolling into the street when parked on a sloping drive way, it is a good practice to turn the wheels as illustrated.

• HEADED DOWNHILL WITH CURB:1 Turn the wheels into the curb and move the vehicle forward until the curb side wheel gently touches the curb.

• HEADED UPHILL WITH CURB:2 Turn the wheels away from the curb and move the vehicle back until the curb side wheel gently touches the curb.

• HEADED UPHILL OR DOWNHILL, NO CURB:3 Turn the wheels toward the side of the road so the vehicle will move away from the center of the road if it moves.

4. Models with Intelligent Key system: Place the ignition switch in the OFF position.

Models without Intelligent Key system: Place the ignition switch in the LOCK position and remove the key.

    AWD warning light
    The AWD warning light located in the instrument panel illuminates when the ignition switch is turned to the ON position. It turns off soon after the engine is started. If any malfunction occurs i ...

    Electric power steering system
    WARNING • If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. •  When the electric power steerin ...

    Other materials:

    B2626 outside antenna
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Disconnect outside key antenna (driver side) connector. 2. Perform “INTELLIGENT KEY” Self Diagnostic Result. Is outside key antenna DTC detected? YES >> Refer to DLK-61, "Diagnosis ...

    Service data and specifications (SDS)
    General Specifications MR16DDT HR16DE, K9K Brake Pedal Brake Booster 2WD 4WD Front Disc Brake MR16DDT HR16DE, K9K Rear Disc Brake ...

    Service information for electrical incident
    Work Flow WORK FLOW Control Units and Electrical Parts PRECAUTIONS • Never reverse polarity of battery terminals. • Install only parts specified for a vehicle. • Before replacing the control unit, check the input and output and functions of the component parts. • Do not apply excessive ...