Nissan Juke Service and Repair Manual : Parking brake switch

Component Function Check

1.CHECK PARKING BRAKE SWITCH OPERATION

Operate the parking brake lever. Then check that the brake warning lamp in the combination meter turns ON/ OFF correctly.

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to BRC-70, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK PARKING BRAKE SWITCH CIRCUIT

1. Turn the ignition switch OFF.

2. Disconnect parking brake switch harness connector.

3. Disconnect combination meter harness connector.

4. Check continuity between parking brake switch harness connector and combination meter harness connector.

5. Check continuity between parking brake switch harness connector and


5. Check continuity between parking brake switch harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.CHECK PARKING BRAKE SWITCH

Check the parking brake switch. Refer to BRC-70, "Component Inspection".

Is the inspection result normal? YES >> GO TO 3.

NO >> Replace parking brake switch. Refer to PB-5, "Removal and Installation".

3.CHECK COMBINATION METER

Check combination meter. Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> Check each pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.

NO >> Repair or replace combination meter. Refer to MWI-69, "Removal and Installation".

Component Inspection

1.CHECK PARKING BRAKE SWITCH

1. Turn the ignition switch OFF.

2. Disconnect parking brake switch harness connector.

3. Check continuity between parking brake switch harness connector.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Replace parking brake switch. Refer to PB-5, "Removal and Installation".

    Stop lamp switch
    Component Function Check 1.CHECK STOP LAMP SWITCH OPERATION Depress brake pedal and check that stop lamp turns ON, or release brake pedal and check stop lamp turns OFF. Is the inspection resul ...

    Brake fluid level switch
    Component Function Check 1.CHECK BRAKE FLUID LEVEL SWITCH OPERATION When the brake fluid is full or empty. Then check that the brake warning lamp in the combination meter turns ON/OFF correctly. ...

    Other materials:

    Operating tips
    • When the shift lever is shifted to the R (Reverse) position, the monitor screen automatically changes to the RearView Monitor mode. However, the radio can be heard. • When the view is switched, the display images on the screen may be displayed with some delay. • When the temperature is extre ...

    Intelligent key warning buzzer
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Intelligent ...

    Excessive consumption
    Description CHART 15:EXCESSIVE CONSUMPTION Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace ha ...