Nissan Juke Service and Repair Manual : Park/neutral position (PNP) switch : Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH
1. Disconnect position switch connector. Refer to TM-77, "Removal and Installation".
2. Check continuity between position switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-77, "Removal and Installation".
Back-up lamp switch : Component Inspection
1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-77, "Removal and Installation". 2. Check continuity between position switch terminals. Is the inspec ...Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, ...Other materials:
Component parts
Component Parts Location
LHD MODELS
1. Multi display unit
2. ABS actuator and electric unit (control
unit)
3. A/C auto amp. (With auto air conditioning)
PTC heater control unit (Diesel engine
with manual air conditioning)
4. ECM (Gasoline engine models)
5. IPDM E/R
6. TCM (Gasoline en ...
B2190 nats antenna AMP
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-200, "Diagnosis Procedure".
NO >&g ...
Rear seat (4WD)
Exploded View
1. Seatback board RH
2. Headrest
3. Headrest holder (locked)
4. Headrest holder (free)
5. Seatback trim RH
6. Seatback pad RH
7. Seatback lock knob
8. Seatback lock knob finisher
9. Seatback lock assembly RH
10. Seat lock cover RH
11. Bush
12. Side hinge
13. Spac ...