Nissan Juke Service and Repair Manual : P1831 VDC operation signal
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Start the engine and drive at 30 km/h (19 MPH) or more.
2. Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is DTC “P1831” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-63, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
With CONSULT-III
Perform self-diagnosis for “ABS”.
Is any DTCs detected? YES >> Check the DTCs. Refer to BRC-142, "DTC Index".
NO >> GO TO 2.
2.ERASE SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.
2. Start the engine and drive vehicle at 30 km/h (19 MPH) or more.
3. Check that ABS warning lamp turns OFF.
Does ABS warning lamp turn OFF? YES >> GO TO 3.
NO >> Refer to BRC-212, "Diagnosis Procedure".
3.CHECK TERMINALS AND HARNESS CONNECTORS
Check 4WD control module pin terminals for damage or loose connection with harness connector.
Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P1831” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".
NO >> Repair or replace error-detected parts.
P1830 ABS operation signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC REPRODUCTION PROCEDURE With CONSULT-III 1. Start the engine and drive at 30 km/h (19 MPH) or more. 2. Perform self-diagnosis for ...P1832 TCS operation signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC REPRODUCTION PROCEDURE With CONSULT-III 1. Start the engine and drive at 30 km/h (19 MPH) or more. 2. Perform self-diagnosis for ...Other materials:
Additional service when replacing TCM
Description
Always perform the following items when the TCM is replaced.
CHECK LOADING OF CALIBRATION DATA
• The TCM acquires calibration data (individual characteristic value) of each
solenoid that is stored in the
ROM assembly (in the control valve). This enables the TCM to perform accurat ...
Parking brake shoe
Adjustment
1. Adjust parking brake lever stroke. Refer to PB-2, "Inspection and
Adjustment".
2. Perform parking brake break-in (drag on) operation by driving vehicle under
the following conditions:
• Drive forward
• Vehicle speed: Approx. 43 km/h (27 MPH) set (constant and forward) ...
B2622 inside antenna
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode.
3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK SUPPORT” of
“INTELL ...