Nissan Juke Service and Repair Manual : P1830 ABS operation signal
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Start the engine and drive at 30 km/h (19 MPH) or more.
2. Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is DTC “P1830” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-62, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
With CONSULT-III
Perform self-diagnosis for “ABS”.
Is any DTCs detected? YES >> Check the DTCs. Refer to BRC-142, "DTC Index".
NO >> GO TO 2.
2.ERASE SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.
2. Start the engine and drive vehicle at 30 km/h (19 MPH) or more.
3. Check that ABS warning lamp turns OFF.
Does ABS warning lamp turn OFF? YES >> GO TO 3.
NO >> Refer to BRC-212, "Diagnosis Procedure".
3.CHECK TERMINALS AND HARNESS CONNECTORS
Check 4WD control module pin terminals for damage or loose connection with harness connector.
Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P1830” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".
NO >> Repair or replace error-detected parts.
P182F coupling temperature sensor left
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 ...P1831 VDC operation signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC REPRODUCTION PROCEDURE With CONSULT-III 1. Start the engine and drive at 30 km/h (19 MPH) or more. 2. Perform self-diagnosis for ...Other materials:
Precaution for Brake Control system
• Always perform a pre-driving check to drive the vehicle.• Always perform a
pre-driving check to drive the vehicle.
• Always check speed and safety while driving the vehicle.
• Always check speed and safety while driving the vehicle.
• To operate CONSULT-III while driving, more than one pers ...
Intake sensor
Exploded View
Refer to HA-97, "Exploded View (Automatic Air Conditioning)".
Removal and Installation
REMOVAL
1. Remove evaporator assembly. Refer to HA-115, "EVAPORATOR : Removal and
Installation".
2. Remove intake sensor from evaporator.
INSTALLATION
Note the followin ...
Removal and installation
PUSH-BUTTON IGNITION SWITCH
Removal and Installation
REMOVAL
1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and
Installation".
2. Remove the push-button ignition switch.
1. Disengage the push-button ignition switch fixing pawls
using minus driver etc.
2. Press the pu ...