Nissan Juke Service and Repair Manual : P1804, P1809 4WD control module

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Turn the ignition switch OFF to ON.With CONSULT-III


1. Turn the ignition switch OFF to ON.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Are DTC′s “P1804 or P1809” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-40, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM SELF-DIAGNOSIS

1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.

2. Turn the ignition switch OFF, and then wait 10 seconds and more.

3. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Are DTC′s “P1804 or 1809” detected? YES >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Check 4WD control module pin terminals for damage or loose connection with harness connector.

If any items are damaged, repair or replace error-detected parts.

    P1808 Wheel speed sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 ...

    Other materials:

    Front door glass
    Exploded View 1. Front door panel 2. Lower sash (front) 3. Sealing screen 4. Pull handle bracket 5. Front door glass run 6. Front door glass 7. Power window motor 8. Front door regulator assembly 9. Lower sash (rear) : Vehicle front Removal and Installation REMOVAL 1. Fully open ...

    Component parts
    Component Parts Location MODELS WITH USB CONNECTION FUNCTION 1. Front door speaker LH 2. Rear door speaker LH 3. Rear door speaker RH 4. Antenna rod 5. Antenna base (antenna amp.) 6. Front door speaker RH 7. Microphone 8. Tweeter LH 9. Steering switch 10. USB connector and AUX jac ...

    Off position warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...