Nissan Juke Service and Repair Manual : P17B7 high clutch solenoid

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine and wait for 5 seconds or more.

2. Check the first trip DTC.

Is “P17B7” detected? YES >> Go to TM-453, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND THE CVT UNIT

1. Turn ignition switch OFF.

2. Disconnect the TCM connector and the CVT unit connector.

3. Check the continuity between TCM harness connector terminal and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK HIGH CLUTCH & REVERSE BRAKE SOLENOID VALVE

Check the high clutch & reverse brake solenoid valve. Refer to TM-454, "Component Inspection (High Clutch & Reverse Brake Solenoid Valve)".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Repair or replace the malfunctioning parts.

Component Inspection (High Clutch & Reverse Brake Solenoid Valve)

1.CHECK HIGH CLUTCH & REVERSE BRAKE SOLENOID VALVE

Check the resistance between the CVT unit connector terminal and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> There is a malfunction of the high & reverse brake solenoid valve. Replace the transaxle assembly.

Refer to TM-508, "Removal and Installation".

    Component Inspection (Low Brake Solenoid Valve)
    1.CHECK LOW BRAKE SOLENOID VALVE Check the resistance between the CVT unit connector terminal and ground. Is the inspection result normal? YES >> INSPECTION END NO >> There is a malf ...

    P17B8 high clutch solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for a ...

    Other materials:

    B210C starter control relay
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-30, "DTC Logic". • When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210C may be detected. DTC ...

    U1001 Can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each c ...

    Precaution
    Service Notice or Precautions for Road Wheel • Genuine NISSAN aluminum wheel is designed for each type of vehicle. Use it on the specified vehicle only. • Use Genuine NISSAN parts for the wheel nuts. • Always use them after adjusting the wheel balance. For the balance weights, use Genuine NIS ...