Nissan Juke Service and Repair Manual : P173B 1GR incorrect ratio
DTC Logic
DTC CONFIRMATION PROCEDURE
CAUTION:
• Be sure to perform “TM-445, "Diagnosis Procedure"” and then perform “DTC
CONFIRMATION PROCEDURE”.
• Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary malfunction.
• Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. Start the engine.
2. Drive the vehicle.
3. Maintain the following conditions for 10 seconds or more.
Selector lever : “L” POSITION Accelerator pedal position : 0.7/8 or more Vehicle speed : 10 km/h (6 MPH) or more
4. Stop the vehicle.
5. Check the first trip DTC.
Is “P173B” detected? YES >> Go to TM-445, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
Is the inspection result normal? YES >> Replace the transaxle assembly. Refer to TM-508, "Removal and Installation".
NO >> Repair or replace the malfunctioning parts.
P173A 2GR incorrect ratio
DTC Logic DTC DETECTION LOGIC DTC COFIRMATION PROCEDURE CAUTION: • Be sure to perform "TM-444, "Diagnosis Procedure"" and then perform "DTC CONFIRMATION PROCEDURE" ...P173C 2GR incorrect ratio
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-447, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • Never perform ...Other materials:
Insufficient heating
Description
Symptom
• Insufficient heating
• No warm air comes out. (Air flow volume is normal.)
Diagnosis Procedure
NOTE:
Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If
any malfunction result or
DTC is detected, perform the corresponding diagnosis.
1.CHE ...
Evap canister
2WD : Hydraulic Layout
EVAPORATIVE EMISSION LINE DRAWING
1.EVAP canister purge volume control
solenoid valve
2. EVAP canister
3. EAVP line
4. Fuel line
NOTE:
Do not use soapy water or any type of solvent while installing vacuum hose or
purge hoses.
2WD : Removal and Installation
REMOV ...
Back door opener switch
Component Function Check
1.CHECK FUNCTION
1. Select “TRUNK” of “BCM” using CONSULT-III.
2. Select “TR/BD OPEN SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Back door opener switc ...