Nissan Juke Service and Repair Manual : P173A 2GR incorrect ratio

DTC Logic

DTC DETECTION LOGIC

DTC COFIRMATION PROCEDURE


DTC COFIRMATION PROCEDURE

CAUTION:
• Be sure to perform "TM-444, "Diagnosis Procedure"" and then perform "DTC CONFIRMATION PROCEDURE".

• Never perform "TC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary malfunction.

• Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine.

2. Drive the vehicle.

3. Maintain the following conditions for 10 seconds or more.

Selector lever : “D” position Accelerator pedal position : 0.7/8 or more Vehicle speed : 45 km/h (28 MPH) or more

4. Stop the vehicle
5. Check the first trip DTC.

Is “P173A” detected? YES >> Go to TM-444, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace the transaxle assembly. Refer to TM-508, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

    P1739 1GR incorrect ratio
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-442, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • Never perform ...

    P173B 1GR incorrect ratio
    DTC Logic DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-445, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • Never perform "DTC CONFIRMATION ...

    Other materials:

    Service data and specifications (SDS)
    Wheel Bearing Drive Shaft *: For measuring position, refer to FAX-81, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 84, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side). ...

    Service regeneration
    Description Service Regeneration is performed with CONSULT-III to reduce particulate matter in diesel particulate filter. Service Regeneration should be performed in the following cases. • ECM enters fail-safe mode because the amount of particulate matter in diesel particulate filter reache ...

    P0131 A/F sensor 1
    DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal is not inordinately low. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ign ...