Nissan Juke Service and Repair Manual : P1739 1GR incorrect ratio

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

CAUTION:
• Be sure to perform “TM-442, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”.

• Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary malfunction.

• Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine.

2. Drive the vehicle.

3. Maintain the following conditions for 10 seconds or more.

Selector lever : “L” POSITION Accelerator pedal position : 0.7/8 or more Vehicle speed : 10 km/h (6 MPH) or more

4. Stop the vehicle.

5. Check the first trip DTC.

Is “P1739” detected? YES >> Go to TM-442, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace the transaxle assembly. Refer to TM-508, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

    P1701 TCM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for a ...

    P173A 2GR incorrect ratio
    DTC Logic DTC DETECTION LOGIC DTC COFIRMATION PROCEDURE CAUTION: • Be sure to perform "TM-444, "Diagnosis Procedure"" and then perform "DTC CONFIRMATION PROCEDURE" ...

    Other materials:

    MR16DDT : Inspection and Adjustment
    INSPECTION Magnetic Switch Check • Before starting to check, disconnect the battery cable from the negative terminal. • Disconnect “M” terminal of starter motor. 1. Continuity test [between “S” terminal (A) and switch body] B : “B” terminal C : “M” terminal • Replace magnetic switch if co ...

    B2099 ignition relay off stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less. • Turn the ignition relay OFF w ...

    Door lock operation warning does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK FUNCTION Check door lock function. Does door lock/unlock using door request switch? YES >> GO TO 2. NO >> Refer to DLK-85, "Component Function Check". 2.CHECK INTELLIGENT KEY WARNING BUZZER Check Intelligent Key warning buzzer. ...