Nissan Juke Service and Repair Manual : P1705 TP sensor

Description

Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

NOTE

:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

1.CHECK DTC DETECTION

With CONSULT-III

1. Turn ignition switch ON.

2. Depress accelerator pedal fully and release it, then wait for 5 seconds.

3. Select “Self Diagnostic Results” in “TRANSMISSION”.

Is “P1705” detected? YES >> Go to TM-241, "Diagnosis Procedure".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Diagnosis Procedure

1.CHECK INPUT SIGNAL

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “DATA MONITOR” in “TRANSMISSION”.

3. Read out the value of “ACC PEDAL OPEN”.

Is the inspection result normal?


Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 2.

2.CHECK DTC WITH ECM

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “SELF-DIAG RESULTS” in “ENGINE”.

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Check the DTC Detected Item.

    P1701 TCM
    Description When the power supply to the TCM is cut OFF, for example because the battery is removed, and the self-diagnosis memory function stops, malfunction is detected. NOTE: Since “P1701” ...

    P1722 vehicle speed
    Description The vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) to TCM by CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDU ...

    Other materials:

    Service Notice or Precautions for Clut
    WARNING: After cleaning clutch disc, wipe it with a dust collector. Never use compressed air. CAUTION: • Clutch fluid use refer to MA-13, "Fluids and Lubricants". • Never reuse drained clutch fluid. • Keep painted surface on the body or other parts free of clutch fluid. If it sp ...

    Removal and Installation
    CAUTION: • Be sure to use genuine exhaust system parts or equivalents which are specially designed for heat resistance, corrosion resistance and shape. • Perform the operation with the exhaust system fully cooled down because the system is still hot just after the engine stops. • Be careful ...

    Main line between DLC and A-bag circuit
    Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect the BCM harness connector. 4. Check the continuity between the data link connector and the BCM harness connector. - With In ...