Nissan Juke Service and Repair Manual : P1612 chain of ECM-IMMU

DTC Logic

DTC DETECTION LOGIC

NOTE

:
• If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000.

Refer to BCS-153, "DTC Logic".

• If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble diagnosis for DTC U1010.

Refer to BCS-154, "DTC Logic".

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-194, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

3. Start engine.

Does the engine start? YES >> INSPECTION END

NO >> GO TO 2.

2.REPLACE ECM

Replace ECM.

Refer to EC-447, "Removal and Installation" (MR16DDT), or EC-805, "Removal and Installation" (HR16DE).

>> INSPECTION END

    P1611 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT ...

    P1614 chain of IMMU-KEY
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT ...

    Other materials:

    Ecu diagnosis informatioN
    TCM Reference Value VALUES ON THE DIAGNOSIS TOOL *1: Means CVT fluid temperature. Convert numerical values for actual fluid temperature °C (°F). Refer to TM-128, "ATFTEMP COUNT Conversion Table". TERMINAL LAYOUT PHYSICAL VALUES *1: This harness is not used. *2: ...

    Unexpected brake pedal reaction
    Description A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed. Diagnosis Procedure 1.CHECK FRONT AND REAR AXLE Check that there is no excessive looseness in front and rear axle. • Front axle: Refer to FAX-41, "Inspection". • Rear axle: ...

    Diagnosis and repair work flow
    Work Flow OVERALL SEQUENCE Reference 1··· Refer to AV-77, "Symptom Table". DETAILED FLOW 1.CHECK SYMPTOM Check the malfunction symptoms by performing the following items. • Interview the customer to obtain the malfunction information (conditions and environment when the malfu ...